Difference between revisions of "Pulse"

From Jon's Wiki
Line 18: Line 18:
  
 
== Dolby Digital and DTS "pass-through" streaming ==
 
== Dolby Digital and DTS "pass-through" streaming ==
There isn't currently a way to pipe the Dolby Digital or DTS streams directly to the amplifier without abandoning Pulse altogether and reverting to ALSA. However, these days decoding even 24/96 surround in Pulse uses pretty negligible CPU, and this way you can play them without it blocking the audio device. It also means you can enjoy all those annoying alarms, random pop-up beeps and messaging alerts while you watch your movies.
+
There isn't currently a way to pipe the Dolby Digital or DTS streams directly to the amplifier without abandoning Pulse altogether and reverting to ALSA. However, these days decoding even 24/96 surround in Pulse uses pretty negligible CPU, and even when using ALSA it blocks the audio device. It also means you can enjoy all those annoying alarms, random pop-up beeps and messaging alerts while you watch your movies.

Revision as of 04:17, 26 May 2012

If you have spent days and days fucking around trying to get sound to work with your NVidia 220GT HDMI, you have to use hw:0,7 not hw:0,3 which is the first thing pulse sees, and you need to unmute it in ALSA.

sudo apt-get install alsamixergui

Run alsamixergui and UNMUTE ALL FOUR FUCKING SPDIF CHANNELS.

Support for 24 bit 96 kHz audio

Make Pulse use 32 bit samples in /etc/pulse/daemon.conf and bump up the sample rate:

default-sample-format = s32le
default-sample-rate = 96000

Surround sound

Since I have a surround HDMI amplifier, I use this in /etc/pulse/default.pa after the autodetect phase (which you might still want for when you plug in USB devices, for instance):

load-module module-alsa-sink device=hw:0,7 channels=6 \
  channel_map=front-left,front-right,rear-left,rear-right,front-center,lfe

and in /etc/pulse/daemon.conf you need:

default-sample-channels = 6
default-channel-map = front-left,front-right,rear-left,rear-right,front-center,lfe

Dolby Digital and DTS "pass-through" streaming

There isn't currently a way to pipe the Dolby Digital or DTS streams directly to the amplifier without abandoning Pulse altogether and reverting to ALSA. However, these days decoding even 24/96 surround in Pulse uses pretty negligible CPU, and even when using ALSA it blocks the audio device. It also means you can enjoy all those annoying alarms, random pop-up beeps and messaging alerts while you watch your movies.